CONTROLS AND
EQUIPMENT
Rear seat bench
Warning
Before
folding the
backrest
down, the
three-point
rear
seat
belt
must
be
pushed
under
the
loop on the
side
trim
panel
to
pre-
vent
it
being
damaged.
Driving
position
I
Please
refer
to the
general
notes
on
i!
page
93.
The seat bench is in the driving position
when the bench is folded back and engaged
securely in the mountings on the floor. The
backrest must also be folded back and en-
gaged securely.
Folding
backrest
down
• On vehicles with rotating single seats*
first remove the head restraints on the scat
bench so that they do not hit the single
seats (see page 77).
• Push lever next to the head of backrest
forwards in direction of arrow.
• Fold backrest forwards.
Folding
backrest
down
• Fold back rear seat backrest until it en-
gages properly. Ensure that the seat belts
are not trapped and damaged when folding
back.
• Reinstall the head restraints in the seatf
bench (see page 77).
Warning
The
rear
seat
backrest
must
be
properly
engaged
so
that
articles
in the
luggage
area
cannot
slide
forward
if the
brakes
are
applied
suddenly.
100
—
SEATS
AND
STOWAGE
CONTROLS AND
EQUIPMENT
Tipping
seat
bench
• Fold backrest forwards.
• Swing luggage compartment cover* for-
wards onto backrest.
• Pull loop on lower part of seat bench
• Tip bench forwards.
Tipping
seat
bench
back
Tip the bench back carefully. Please ensure
that no items are caught up or damaged
when folding back.
[ B70-386C~[
Removing
rear
seat
bench
Please
refer
to the
general
notes
on
page
93.
• Fold backrests of centre seat bench and
folding seat* forwards
• Pull seat frame
trim*
off forwards
• Remove head restraints and fold back-
rest forward
• Tilt the luggage compartment cover* for-
ward onto the backrest and fold the bench
forward
• Loosen and remove the two rear bolts
(upper illustration) using the vehicle tools.
• Carefully fold seat back
• Fold back carpet* to attain access to the
front bolts
SEATS
AND
STOWAGE
—
101
To Next Page
Loading...
