VOLO VP-16 - Default Chapter; Table of Contents

FW1.49.57英文版FW1.49.57英文版FW1.49.57英文版FW1.49.57英文版FW1.49.57英文版FW1.49.57英文版
WARNING
Do not use OBD splitters or stack other OBD devices with the VP16, including
scanners, monitors, modules, or other tuners. Additional devices will interfere
with the VP16 and cause erratic results.
Never Operate Your Vehicle In An Unsafe Manner
Do Not Use Touchscreen While Driving
Come to a to adjust settings or review information.complete stop
Never exceed legal speed limits on Public Streets. Performance tests, such as
Dyno run or acceleration tests, should only be performed on a closed circuit. A
loss of control from speeding could occur, causing serious or fatal injuries to
yourself or other motorists.
Potential Risk of Damage
Performance Testing/tuning is inherently stressful to your vehicle’s engine and
drivetrain. It is your responsibility to ensure your vehicle is in good working order
and capable of handling these stresses before proceeding.
Battery Drain
The VP16 will automatically enter low-power Sleep Mode when the vehicle is
turned off. The VP16 Should be disconnected if you plan to park your vehicle for
more than a week.
Bus Interference
CONTENTS
WARNING
OVERVIEW
VP-16Setup
VP-16FirmwareUpdateProcess
Installation
Un-installation,Re-installation,andRe-programming
MajorFeatures
-Gauges
CustomizeGauges
-PerformanceTests
-Tuning
-Dyno
-PWM
-Mode
-Diagnosis
-Settings
P.02
P.03
P.06
P.08
P.11
P.14
P.15
P.16
P.21
P.27
P.28
P.29
P.31
P.32
P.33
P.34
1
2