VOLTCRAFT 2633260 - Page 17

1. Introduction
Dear customer,
Thank you for purchasing this product.
If there are any technical questions, please contact: www.conrad.com/contact
2. Explanation of symbols
The symbol with the exclamation mark in the triangle is used to indicate important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on operation.
3. Intended use
The product is designed to measure and display rotation speed and belt speed. Measurements
are either non-contact via the built-in laser or per direct contact using the included adapters.
The measured values are shown on the 5-digit LC display. The product features a memory with
space for 40 measured values which allows the user to retrieve the maximum, minimum and
average values from a stored measuring procedure.
Power supply is via a 9 V block battery.
The product is intended for indoor use only. Do not use it outdoors. Contact with moisture must
be avoided under all circumstances.
If you use the product for purposes other than those described, the product may be damaged.
Improperusecanresultinshortcircuits,res,electricshocksorotherhazards.
The product complies with the statutory national and European requirements. For safety and
approval purposes, you must not rebuild and/or modify the product.
Readtheoperatinginstructionscarefullyandstoretheminasafeplace.Makethisproductavail-
able to third parties only together with the operating instructions.
All company names and product names are trademarks of their respective owners. All rights
reserved.
17