VOLTECH AT3600 USER MANUAL TEST PROGRAM HANDLING
2.4. DELETING A TEST PROGRAM
When the Server stores the test program on your PC hard disk, the DOS filename
used differs from the part name specified. The Server uses an algorithm to encode a
unique filename for each part.
When you open a part, you are shown the part name, not the filename. For this reason
if you use MS Windows File manager to view the Server program directory, you will
not see any meaningful part names.
If you need to remove a part from the Server program directory, a button has been
provided within the PART, OPEN dialogue.
Select the part to be deleted and press the DELETE button.
You will then be prompted to enter the password (as defined when installing the
server software) to allow the part to be deleted.
The program will then be removed from the directory.
i
IMPORTANT: Once a part has been deleted it may not be recovered. Before
deleting a part it is advisable to open and view to ensure you are deleting the
correct test program.
USING THE SERVER VPN 98 - 024 PAGE 4.2.5.
To Next Page
Loading...
