TEST PROGRAM HANDLING VOLTECH AT3600 USER MANUAL
PAGE 4.2.6. VPN 98 - 024 USING THE SERVER
2.5. GROUPING TEST PROGRAMS
Programs that are used on the transformer tester at similar times may be grouped for
convenience. For example, a number of transformers all based on the same bobbin
may be tested at the same time.
When a program group has been defined it may be downloaded to the tester. Each of
the parts within the group will then be available for ‘local’ use. The parts will be
stored in non-volatile RAM. No programs are lost after power-down.
The following dialogue is used to configure groups and may be located under the
Setup menu in the Server:
Double-clicking on any part in the left hand list will add it to the right hand, grouped
list.
When you have completed editing a group you will see it added to the available group
list. To transfer the group to the tester it must be requested by the tester. See Chapter
2 of the manual for details.
i
IMPORTANT: The group function does not store a new copy of each part when
a group is defined. Only reference is made to the part being in a group. DO
NOT delete a part after including it in a group other wise the part will be lost,
and the group rendered invalid.
To Next Page
Loading...