TEST RESULTS HANDLING VOLTECH AT3600 USER MANUAL
Float value giving the minimum limit for the test TestNumber.
“NO LIMIT” This test has no minimum limit.
GetMaxLimit (LPCSTR ComPort, short TestNumber)
Float value giving the maximum limit for the test TestNumber.
“NO LIMIT” This test has no maximum limit.
GetTestStatus (LPCSTR ComPort, short TestNumber)
Returns four digit hex string (“####”) giving the test status as seen on editor
results screen.
GetTestMnemonic (LPCSTR ComPort, short TestNumber)
Returns the test mnemonic as a string, i.e. “LBAL”.
GetTestUnits (LPCSTR ComPort, short TestNumber)
Returns the test units as a string, i.e. “Ohm”.
GetCompensationStatus (LPCSTR ComPort)
“NO COMPENSATION STATUS” No status received yet.
“No Fixture Compensation” Program has not been
compensated.
“Fixture Compensation: successful” Compensation all OK.
“Fixture Compensation: fail” + ExtraString Compensation has failed.
GetUnitType(LPCSTR ComPort)
Returns “AT3600”, “AT1600” or ”ATi” depending on the type of instrument
connected to the ComPort.
GetResult (LPCSTR ComPort, short TestNumber)
The number returned is a float representing the value of the result measured or a
zero if no result was available.
This function is included for compatibility with older versions of the Voltech AT
Server. It is not recommended for new applications.
PAGE 4.3.26. VPN 98 - 024 USING THE SERVER
To Next Page
Loading...