VOLTECH AT3600 USER MANUAL DESCRIPTION OF THE FIXTURE SYSTEM
2.2 FIXTURE PARTS AVAILABLE FROM VOLTECH
1. FIXTURE PLATE
Designed for mounting existing fixtures to an AT series tester the fixture plate
comprises:
• Item 1, Base plate (including contact pins) with cover.
• Item 2, Test piece interface plate.
• Fixings for above.
2. CUSTOM FIXTURE KIT
A kit of parts for constructing your own fixtures. Interconnecting wire, test probes or
clips and a drilling template will also be required. The custom fixture kit comprises:
• Item 1, Base plate (including contact pins) with cover.
• Item 2, Test piece interface plate.
• Item 3, Probe housing box.
• Item 4, Bezel.
• Item 5, Guides (12 off)
• Fixings for above.
3. 40 SOCKET FIXTURE
A fixture board fitted with 40 4mm sockets. 20 red (power) and 20 black (sense). The
sockets are wired to the 40 contacts which align with the tester's 40 nodes.
This fixture may be used for convenient wiring to existing fixtures or as a means of
connecting flying leads and clips for use in developing test programs or testing parts
in a design laboratory.
4. CLAMP
The hand clamp is supplied with 7 height blocks and fixings.
5. TOOLING
Drilling templates are available in a variety of sizes as described on page 5.2.5.
FIXTURES VPN 98 - 024 V07 PAGE 5.2.7.
To Next Page
Loading...
