EXECUTE MODE VOLTECH AT3600 USER MANUAL
3.3. STOP ON FAIL
‘Stop on Fail’ is another program option that is either enabled or disabled when the
program is created (see Chapter 3 - ‘The Test Program Editor’).
When enabled, it will cause the measurements to be terminated after each test which
has produced a ‘Fail’ result. A display similar to one of the following will then be
seen:
1
Part name / number.
2
Failing test number.
3
Graphical qualification of the failure showing the value measured with
respect to the range of legal values, where:
Box – Represents the legal limits for the test
Vertical bar – Represents the value measured. (Replaced by an
arrowhead to represent higher or lower, when the measured value is
significantly outside of the legal range – see notes below.)
4
Value measured, with appropriate units.
5
Available soft-key functions.
Note:
The third line showing the graphical comparison of the measured value and test limits
has a logarithmic scale. The measured value may be represented by either a vertical
bar (as shown) when it lies within the range that can be displayed on the LCD, or by
an arrowhead (< or >) at the end of the horizontal bar when it lies outside the range
that can be displayed on the LCD.
PAGE 6.3.12. VPN 98 - 024 FRONT PANEL OPERATION
To Next Page
Loading...