WARRANTY INFORMATION VOLTECH AT3600 USER MANUAL
1.2. SERVICE AND CALIBRATION
To confirm the accuracy of your AT3600 tester, a calibration check should be carried
out every 12 months.
Calibration is carried out using a special fixture as described in the next section. The
calibration can be performed by an authorized Voltech service center or at your own
facility if you have the required equipment
For details of calibration facilities and any other service request, please contact your
supplier. Voltech strongly recommends that you discuss your service requirements
with your supplier before service is needed. Extended warranty and full service
agreements are available.
1.3. VOLTECH AT CALIBRATION SYSTEM
Calibrates AT3600 •
•
•
•
•
•
•
Mimimises production down time – return to service centre not required.
Calibrates tester to full specification - including high voltage tests.
Precision circuits and components built-in for reliable, error-free calibration.
Semi or fully-automatic calibration process controlled by easy-to-use PC software.
Voltech recommends that the AT3600 is calibrated every 12 months to ensure
optimum measurement accuracy. The calibration system is designed for use by
owners of Voltech AT testers and third party calibration companies who regularly
calibrate testers or who wish to avoid the production downtime of returning a tester to
a Voltech service center.
Complete record of results stored on PC.
Prints formal calibration certificate showing verification results.
PAGE 9.1.2. VPN 98 - 024 WARRANTY AND SERVICE
To Next Page
Loading...