VOLTECH AT3600 USER MANUAL SAFETY SYSTEMS
SAFETY SYSTEMS VPN 98 - 024 PAGE 10.11.
(c)
(d)
Where ‘XXXX’ is the appropriate test mnemonic.
Operation will remain suspended at this point until the safety system indicates that it is
safe to proceed, after which test execution will carry on as normal. If you do not wish
to continue from this point, pressing the STOP soft-key will halt the test execution and
return the display to the appropriate higher level menu selection.
If the light curtain is broken after the measurement has started, then the test will be
stopped, and the high voltage source shut down. The front panel of the tester will show
a message containing the word ‘STOP’, again with the exact text varying depending
upon the operation that you were trying to perform. Examples are as follows:
(a)
To Next Page
Loading...
