QUICK START TUTORIAL VOLTECH AT3600 USER MANUAL
PAGE 2.3.12 VPN 98 - 024 GETTING STARTED
2.3.2 QUICK START TUTORIAL – THE SERVER
TRANSFERRING THE PROGRAM TO THE SERVER
The Voltech Server software is supplied with every AT3600. The use of the Server
software is required for handling and storage of test results and is recommended for
handling large numbers of different test programs.
Having created, saved and tested the program TUTORIAL using the Editor, you are
now in a position to run it again on your AT Series Tester, but this time using the
Server. The procedure for transferring the program to the Server archive will depend
on where you have installed the Editor and Server programs.
EDITOR AND SERVER ON SEPARATE PC’S
In many situations the Editor and Server would be installed on separate PC’s (as
shown in the illustration on page 2.2.2). In this situation, the AT3600 is used to
perform the transfer.
Before proceeding further, make sure that all the following have been set up:
• The interface cable between the tester’s Auxiliary Port and the selected COM Port
on the Editor PC is correctly fitted, and that the COM Port is correctly configured
in the Editor software (see page 2.2.5).
• The interface cable between the tester’s Server Port and the selected COM port on
the Server PC is correctly fitted, and that the COM Port is correctly configured in
the Server software (see page 2.2.8.)
• Both the Editor and the Server software packages are running.
• The tester is still powered on as described above.
To transfer the program, from the Top Level menu bar, select
Server
Download Program
The Editor will now down-load
the test program to the Server
using the AT3600.
After a few seconds, you should see a message to say that the Download was
successful.
If you see a message indicating that the download has failed, check your cable/COM
Port connections and try again. If the download continues to fail, reboot both PC’s
and try again.
To Next Page
Loading...