VOLTECH AT3600 USER MANUAL QUICK START TUTORIAL
GETTING STARTED VPN 98 - 024 PAGE 2.3.13.
EDITOR AND SERVER BOTH ON A SINGLE PC
If the Server and Editor are installed on the same PC, the easiest way to transfer the
test program to the Server is to use the Save As menu in the Editor:
From the Top Level menu bar,
select
Part >
Save As
At the dialogue box, type in the
part name
TUTORIAL
as before, and change the
directory to the one selected
for program storage
e.g. C:\AT3600\SERVER
when the Server was installed (page 2.2.6.).
Click on the OK button to close the dialogue box and save the test program in the
Server program directory.
The next section of the Tutorial demonstrates running the program on the AT3600
tester from the archive on the Server. Before proceeding to that section, if the Server
and Editor are using the same COM-Port on the single PC, re-allocate the COM-Port
from the Editor to the Server:
• Close down the Editor by clicking on
Part >
Exit
in the Top Level menu.
• Start the Server by double clicking on its Windows icon.
• Configure the COM-Port as shown on page 2.2.8.
• Remove the cable between the AT Auxiliary Port and the PC COM-Port.
• Connect the cable between the AT Server Port and the PC COM-Port
To Next Page
Loading...