Need help?Do you have a question about the VOLTIGEUR EPO 3D PLANE and is the answer not in the manual?
Glue the stabilizer to the fuselage and use foam to fill the gap at the rudder root.
Glue hinges, leaving 2mm out, and clean excess glue to prevent locking.
Install the landing gear using two supplied screws and washers.
Insert plastic tube liner into rudder and glue tail wheel base into recess.
Insert carbon tube through fuselage, connect wings, and secure with nylon screws.
Attach propeller, spinner base, and tighten nut to secure the collet.
Insert the spinner cap and secure it in place with the supplied screws.
Install radio gear and secure it in place using sticky Velcro or similar methods.
Follow indications for Sport flying and 3D aerobatics travel and expo settings.
To Next Page
General