Depending on the symptoms of the machine we can detect the likely cause and solve the problem.
In any other case, take the machine to your nearest after sales service.
Problem
The engine stops when started.
Plug or connector in a bad state.
Cable extension faulty.
Internal cabling faulty.
Switch faulty.
Blunt blade.
Hopper, ejection mouthpiece or blades
blocked.
Blade blocked by strange element.
Screws of the blade loose.
Blades loose.
Blades damaged.
Strange and hard elements blocking the
blades.
Machine works sporadically.
Performance of the machine is
inadequate.
Blade does not turn.
Excessive vibrations or noise.
Plug or connector in a bad state.
Switch damaged.
Security switch activated.
Cable damaged.
Connect to mains.
Check the cable extension and substitute
if necessary. Stop the machine,
disconnect the machine and check the
hopper and blades.
Substitute blades.
Stop the machine, unplug and clean the
shredding conduct and the blades.
Stop the machine, unplug and unblock
the blades.
Tighten the blades following steps in
blade maintenance.
Tighten blades, Change blades.
Clean entry conduct and blades.
Try another plug. If the machine does not
start, take to nearest service agent.
Take the machine to after sales service.
Press the restart button.
Take the machine to after sales service.
Never repair cable using tape.
Cause Action
9. TROUBLESHOOTING
To Next Page
Loading...