Why is the Voltronic Power Galleon II 3P UPS battery backup time so short?
If the battery backup time of your Voltronic Power UPS is shorter than expected, the batteries may not be fully charged. Charge them for at least 7 hours and check the battery capacity again. If the issue continues, the batteries might be defective and you should contact your dealer to replace the battery.
What to do if Voltronic Power Galleon II 3P shows fault code 43?
If fault code 43 is displayed on your Voltronic Power UPS, it means the UPS overload has lasted too long, causing the UPS to fault and shut down automatically. To resolve this, remove some of the connected devices from the UPS output and then restart the UPS.
Why is Voltronic Power UPS showing warning code 02?
General| Model | Galleon II 3P |
|---|---|
| Category | UPS |
| Input Frequency | 50/60 Hz |
| Output Power Factor | 0.9 |
| Input Voltage | 380/400/415 VAC |
| Input Voltage Range | 304 ~ 477 VAC |
| Output Voltage | 380/400/415 VAC |
| Transfer Time | 0 ms |
| Communication Interface | RS232, USB, SNMP (optional) |
| Operating Temperature | 0 ~ 40°C |
| Humidity | 0 ~ 95% (Non-condensing) |
| Battery Type | Sealed Lead-Acid (SLA) |
Procedures and safety precautions for installing the UPS unit, including wiring and location.
Critical warnings related to electrical connections, grounding, and potential hazards during UPS setup.
Instructions and warnings for operating the UPS, covering safe power disconnection and system integrity.
Detailed instructions for installing a single UPS unit, including wiring specifications and safety.
Guidance on installing multiple UPS units in a parallel configuration for increased capacity.
Step-by-step guide for operating the UPS in single-unit configurations, including power on/off.
List of fault codes, their associated events, and relevant icons.
To Next Page