Station Handling
Active Station
Shifting, adjusting speed, trimming, and performing EVC settings and calibrations is only possible on an active
station.
On a boat with one station, the station is always active. On a boat with two or more stations, the main station
automatically becomes active when the EVC system is started up with the ignition key(s). If the engine is started
from a secondary station that station automatically becomes active instead.
During engine start the EVC system sometimes restarts automatically. If this happens, the main station
becomes active even though the start was performed from a secondary station.
The following instructions apply to both single engine and twin engine installations. On a single engine
installation, only one LED will light up. On twin engine installations, both LEDs will light up.
Using Station Panel
51820
The gear must be in neutral when changing stations.
If the station is inactive, activate the helm station with
a single press of the button. Pressing again locks the
helm station. To render the helm station inactive, hold
the button down for 3 seconds.
Inactive Helm Station
Active Helm Station
Locked Helm Station
Using Remote Control Button
51813
The gear must be in neutral when changing stations.
If the station is inactive, activate the helm station with
a single press of button 11. Pressing again locks the
helm station. To render the helm station inactive, hold
the button down for 3 seconds.
Operation
47701898 12-2010 79
To Next Page
Loading...
