DESCRIPTION
Front seats
The front seats can be slid back-
wards or forwards after the knob
on the outside of the seat is pressed
down. Exert leverage with your feet
on the floor and slide the seat to
the desired position.
If necessary, the seats can be moved
25 mm (1") further to the rear than
permitted by the slide rails by using
the extra holes in the seat frames.
The backrest inclination of the front
seats is smoothly adjusted by means
of an adjuster knob located at the
outside of the seat frame at the
bottom.
On the two-door model the backrest
is
locked in the raised position by
means of a catch. In order to tip
the backrest forwards the catch at
the rear edge of the seat frame must
be lifted backwards and upwards.
The front seat is also provided with
an adjustable lumbar support. For
adjusting this, the backrest is pro-
vided with holes on both sides. To
tension the lumbar support, turn the
screw clockwise and vice versa.
The inclination of the whole seat
can
be adjusted
with the eyelet
screw at the front under the seat.
Remove the screw which goes
through the eyelet and tip the seat
backwards as shown in the figure.
Then slacken the locknut on the
floor
and screw the eyelet screw
upwards or downwards to the de-
sired height. Then secure the eyelet
screw with the locknut.
The whole seat can also be raised or
lowered, which is done as follows
Remove the seat cushion, unscrew
the two bolts on the seat frame
attachment and then place them in
one of the other holes in the bracket.
The front seat backrest has built-in
attachments for fitting a headrest.
18
To Next Page
Loading...
