26
IMG-
214121
Take a bracket, two bolts and washers from the kit. Fasten the
bracket in the existing holes on the left side of the oil cooler.
Note!
The screws are self-tapping so it may be slow inserting them.
Make sure that the screws are centred straight into the holes,
so that the screw heads are flat against the bracket.
27
IMG-
214122
Applies to vehicles with 2 wheel drive
Take the heater, rubberized clamp and bolt from the kit. Fasten
the heater with the clamp in the upper hole in the bracket. The
hose connections on the heater should point backwards.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
To Next Page
Loading...
