Service and maintenance
Lubrication and service chart 157
*) Manual greasing
**) Oil lubrication
***) Check for the first time at 250 hours and then every 2000 hours.
****) Or when changing the engine's oil filter. If the filter becomes clogged earlier, it must be replaced.
*****) For conditions for the interval of 500 hours to apply, see page 103.
Measure Page Item
DAILY (every 10 hours)
Check the brake function 2
Check function of control lamps, operating controls, travel and
working lights, and that there are no leaks.
2
Lubricate frame joint* 136
Measure Page Item
EVERY 50 HOURS
After carrying out Daily service
Check the oil in oil bath air cleaner (optional equipment) 114
Warranty inspection should be carried out after the first 100 hours according to Service Programme
Measure Page Item
EVERY 250 HOURS
After carrying out Daily and 50 hour services
Check oil level, frame joint bearing** 137 3
Check for leaks from dropbox (visual check) 133 4
Check oil level, brake cooling oil 141
Check belt tension, alternator and AC compressor
(optional equipment)***
125 and 148 6
Lubricate steering joints and steering cylinder rear bearings 10
Lubricate tipping joint bearings 7
Lubricate tipping cylinder bearing 9
Grease propeller shafts, dropbox 19
Measure Page Item
EVERY 500 HOURS
After carrying out Daily, 50 and 250 hour services
Check brake discs, wear. 140 11
Check air pressure and wear, tyres 143 12
Check condenser 148 13
Check steering joint bearings 14
Check anti-freeze, coolant 118 15
Check electrolyte level, battery 122 5
Change fuel filter**** 107 16
Change filter, water trap**** 107 17
Change oil and oil filter, engine***** 105 18
Grease propeller shaft, dropbox – front axle 10
To Next Page
Loading...
