Maintenance and Service 105
4. Draglink and steering shaft: Use a lithium-based grease with
specification API NLGI No. 2.
5. Kingpin, upper and lower: Use a lithium-based grease with
specification API NLGI No. 2.
Always grease a Volvo front axle with the wheels on the ground.
Non-Volvo axles are typically greased with the wheels on the ground. Consult
with the axle manufacturer for the latest recommendation.
6. Tie-rod: Use a lithium-based grease with specification API NLGI No. 2.
Volvo axles may use a greased-for-life tie-rod. No provisions for adding
grease are available.
7. Brake fluid and clutch reservoir: Check the fluid level in the reservoir.
Add brake fluid if necessary. Use only DOT 4 brake fluid in the clutch
release system. Mixing DOT 4 brake fluid with petroleum-based oil will
cause seal damage which will cause leakage.
8. Clutch bearing linkage: Use a lithium-based grease with EP additives to
specification API NLGI No. 2.
Inspection cover removal is necessary. Lubricate according to Eaton's
lubrication document and reinstall the inspection cover.
9. U-Joints: Use a lithium-based grease with EP additives to specification
API NLGI No. 2.
USA22978.bk.book Page 105 Wednesday, July 9, 2008 9:09 AM
To Next Page
Loading...
