Lamination of Reinforcement
Beams
Lamination layers
Layer # Mat Total density
g/m
2
(oz/yd
2
)
Thickness, hand lamination
mm (in.)
1 E-BXM (+45°/-45°) or E-LTM
(0°/90°), or both alternately
Max 1075 (31.7) -
Requirements for completed lamination
≥ 12 ≥ 12,900 (380.6) ≥ 12.0 (0.5)
IMPORTANT!
Mats with alternative fiber directions that have a den-
sity lower than 1075 g/m
2
(44.3 oz/yd
2
) may be used
as long as the minimum requirements for the number
of layers, total density and total thickness are fulfilled.
IMPORTANT!
Secondary bonding must be avoided during lamina-
tion; refer to General page
51.
Fitting against reinforcement ring.
The mats must follow the reinforcement ring contours
strictly and reach up beyond the line marked in the fig-
ure.
Layer # 1
Lay a layer of mats that extend (A) at least 100 mm
(4") out from the ring. Allow each mat to overlap the
adjacent mat by at least 50 mm (2").
Installation, Volvo Penta IPS
76 47704162 10-2014 © AB VOLVO PENTA
To Next Page
Loading...
