54 Additional Safety Features
Safety Restraint — VN-420, VN–610 and VN–660
The restraint has latches in one end and
buckles in the other so it can only be in-
stalled one way. Connect the restraint to the
back wall and the buckles on the floor. Con-
nect the side tethers and adjust the straps to
form a “tent” over the bunk (VN-660 upper
bunk does not have the “tenting” feature).
W8002039
Safety Restraint — VN-770
Connect the restraint to the back wall first.
The wall connectors are located in the stor-
age units. Connect the lower part of the
restraint to the lower buckles. Connect the
side tethers and adjust the straps to form a
“tent” over the bunk.
NOTE! The restraints for top and bottom
bunks are different. Each belt can only be
installed to the correct bunk.
To Next Page
Loading...
