Von Duprin 6300 User Manual

Installation Instructions
IS6300-R05/10
Copyright © 2011 Ingersoll-Rand. All rights reserved.
6300 Surface Mounted Rim Strike
Important: The New 6300 Electric Strike is never to be used as a door stop. Please install stops on frame
in appropriate locations. Ensure the exit device functions as intended for life safety concerns by verifying
electric strike and exit device compatibility. Maximum latch projection is essential to obtain full holding force.
When installed in a fail secure manner, the local Authority Having Jurisdiction shall be consulted with regard
to the use of selected panic hardware to ensure emergency exit from the secured area.
Catalog Specifications
Model Mode Voltage Current Duty Amps Ohms
6300 Fail Secure 12V DC Continuous 0.50 22
6300 Fail Secure 24V DC Continuous 0.24 89
Fail Locked = Fail Secure = FSE DC = Direct Current
Continuous Duty = Energized 1 minute or more
Dimensional Details
3/4"
(19.0mm)
1-5/8"
(42.0mm)
9"
(228.6mm)
8-1/4"
(209.6mm)
1-3/4"
(44.5mm)
5-1/2"
(139.7mm)
HORIZONTAL
ADJUSTMENT
MOUNTING
HOLES
LOCK DOWN
HOLES

Von Duprin 6300 Specifications

General

Brand	Von Duprin
Model	6300
Category	Clock
Language	English

Summary

6300 Surface Mounted Rim Strike

Catalog Specifications

Catalog specifications for the 6300 Electric Strike, detailing models, voltage, current, duty, amps, and ohms.

Dimensional Details

Physical dimensions and key measurements for the 6300 Surface Mounted Rim Strike.

Installation Instructions

Determine Centerline and Position Template

Align exit device centerline with frame stop and position template against the closed door for center-punching.

Drill and Tap Holes

Drill and tap two mounting holes and drill the wire access hole as indicated.

Test Fit and Connect Wiring

Test electric strike for full latch engagement and make wire connections from power source.

Mount and Adjust Electric Strike

Mount strike using provided screws, adjust horizontally for full latch engagement, and secure locking holes.

6300 Template Instructions

Template Alignment and Marking

Align template with centerline and closed door, then center-punch mounting and wire access holes.

Template Hole Specifications

Details on hole sizes and types for mounting and wire access on the frame.