vonado 42109 - User Manual

App-Controlled Top Gear Rally Car 42109 Lighting Kit
Package contents：
 4 x 15cm White Dot Lights
 4 x 15cm Red Dot Lights
 2 x 15cm Blue Dot Lights
 2 x 15cm head lights
 1 x Warm White Strip Light
 1 x Red Strip Lights
 1 x 15cm Connecting Cable
 2 x 30cm Connecting Cables
 2 x 8-port Expansion Boards
 1 x Round Coin Cell Battery Pack
Extra pieces
Important things to note:
When installing dot lights
Make sure they are correctly placed (Yellow LED package is exposed). You can put they either
on the top of the studs or between studs.
Place wires on the surface or under the building blocks.
The wire can be place between the building blocks or under the block, but they should be
placed between the studs correctly.

Summary

Important Notes and Package Contents

When Installing Dot Lights

Ensure dot lights are correctly placed with the yellow LED package exposed, on or between studs.

Connecting Micro Connectors to Expansion Board

Connecting Cables to Strip Lights and Battery Installation

Connecting Cables to Strip Lights

Connect strip light cables carefully, ensuring the exposed wires face down for correct insertion.

Battery Installation Polarity

Pay attention to positive and negative terminals when installing the battery case for proper function.

Connecting Cables to Remote Control Board

Connecting to Sensor and USB Cable

Connecting Cable to Sensor

Connect the cable to the sensor with the connecting cable side facing down to the bigger port.

Connecting the USB Cable

Connect the USB cable to the designated port as shown in the diagram.

Installing Front Headlights

Routing Headlight Cables

Thread headlight cables through the car body to the bottom and connect to an 8-port expansion board.

Mounting Expansion Board and Installing More Front Lights

Tuck excess cables, secure the expansion board, and repeat headlight installation for the other side.

Installing Front White Dot Lights

Remove stickers, attach a 15cm white dot light to the blue piece, securing the light.

Installing Additional White Dot Lights (Front)

Install another white dot light, route cables to the back, secure, and reconnect lights.

Connecting Front White Dot Lights to Expansion Board

Thread and tuck cables for two white dot lights, then connect them to the expansion board.

Routing Rear Cables to Cockpit

Connecting Warm White Strip Light

Thread cables, attach a warm white strip light, connect its cable, and prepare for mounting.

Mounting Strip Light on Cockpit

Connect the strip light cable, stick the light to the cockpit top, and thread its cable through.

Cable Management for Rear Components

Thread cables through the car body, tire, and pull them towards the rear.

Installing Rear Components and Blue Lights

Preparing Blue Dot Lights for Pipes

Take a 15cm blue dot light and a round piece with a hole; thread the light through the hole.

Connecting and Routing Blue Dot Lights

Thread cables through pipes and car body, pull to bottom, tuck, wind, and connect to expansion board.

Installing Second Blue Dot Light for Pipe

Repeat steps to install the second 15cm blue dot light and round plate for the other pipe.

Installing Taillights (Red Dot Lights)

Connecting Red Dot Lights to Taillight Assembly

Thread cable through the hole, secure with red plate, and repeat for the second red dot light.

Connecting Taillights to Expansion Board

Connect cables of the two red dot lights to the expansion board and reconnect rear pieces.

Installing Red Strip Light

Final Rear Connections and Battery Pack Installation

Connecting Battery Pack to Expansion Board

Connect the cable of the Round Coin Cell Battery Pack to the expansion board underneath the car.

vonado 42109 Specifications

General

Brand	vonado
Model	42109
Category	Light Fixture
Language	English