Vortex Pro Binocular Adapter

To Next Page

INCLUDED:

a. Adapter Post

b. Threaded Stud

c. 1.3mm Allen Wrench

d. 2.0mm Allen Wrench

INSTRUCTIONS:

1. Remove cap covering the binocular tripod adapter socket.

2. Insert the threaded stud into the binocular tripod adapter

socket and tighten using the 2.0mm Allen wrench.

DO NOT OVERTIGHTEN.

3. Using the 1.3mm Allen wrench, tighten the set screw in

the threaded stud. DO NOT OVERTIGHTEN.

4. Attach adapter post to the tripod plate utilizing the

tripod’s 1/4-20 mount.

5. Mount the binoculars to the tripod by inserting the

threaded stud into the adapter post. Tighten by hand

using the locking knob until secure.

Need help?

Do you have a question about the Vortex Pro Binocular Adapter and is the answer not in the manual?

Summary

Included Components

Adapter Post

The main connecting piece for the tripod.

Threaded Stud

Screw that attaches to the binoculars.

Allen Wrenches

Tools provided for tightening.

Assembly and Operation Instructions

Prepare Binocular Socket

Remove the cap from the binocular tripod adapter socket.

Install Threaded Stud

Insert and tighten the stud into the binocular socket using the 2.0mm Allen wrench.

Tighten Set Screw

Secure the threaded stud with the 1.3mm Allen wrench.

Attach Adapter to Tripod

Connect the adapter post to the tripod plate using the 1/4-20 mount.

Mount Binoculars

Secure the binoculars to the adapter post by hand.

VIP Warranty Information