STRIKE EAGLE
®
10 11
Illumination
The Strike Eagle
®
1-8x24 FFP uses a variable intensity
reticle illumination system, found on the optic’s
left-hand side. To activate the illumination, rotate the
illumination dial to the
desired intensity setting.
The Strike Eagle
®
has
nine daylight illumination
settings, and two night
vision compatible settings.
To turn the illumination
off, dial the Illumination
Dial to “0.”
Note: When the illumination is off, the reticle will appear black.
Battery Installation/Replacement
To install/change the battery, unscrew the Illumination
Dial’s cap and install a new CR2032 battery with the
positive (+) facing out.
Replacing the Battery
1. While holding the Illumination Dial, unscrew the
cap using the coin slot.
2. Remove the CR2032 battery.
3. Replace with a new CR2032 battery with the
positive side (+) facing out.
4. Reinstall the Illumination Dial Cap.
Illumination
Control Dial
Battery Cap
RIFLESCOPE MOUNTING
To get the best performance from your riflescope,
proper mounting is essential. Although not difficult,
the correct steps must be followed. If you are unsure of
your abilities, use the services of a qualified gunsmith.
Please take note of the instructions on the following
pages. For the proper scope mounting procedure
go to VortexOptics.com/vortex-nation-videos for a
video tutorial.
Riflescope Mounting Checklist
• Gun vise or a solid platform for your rifle
• Scope rings
• Torque wrench
• Reticle leveling tool(s) (such as feeler gauges or
bubble levels and a plumb bob)
Recommendation: Pick up
the Vortex
®
Torque Wrench
Mounting Kit, which comes
with the complete set of bits
needed to install Vortex
®
scopes and rings.
To Next Page
Loading...
Need help?
General