Getting Started
4 Vitalizer Plus User’s Guide
Operation
Follow these easy steps to assemble you New Vitalizer Plus Advanced
Water System:
1. Hand wash using a sponge with mild detergent the following: pitcher,
lid, spinner and silicone ring. Rinse well.
2. Rinse the mineral cube under cold running tap water for a few
seconds. Wipe it with wet soft sponge or washcloth without
detergent. Rinse well. Do not use detergent or soap to wash the
mineral cube.
3. Place the spinner in the middle of the mineral cube/basket.
4. Position the mineral cube inside the pitcher, push it down at the
bottom center, and rotate it to the right with a little pressure to
secure the cube.
Initial Cleaning:
· Fill the pitcher with filtered water.
· Place pitcher on top of the base then press power button.
· Press the minute button, choose 9 minutes then press start
button.
· During the first cycle, it is normal that small particles could
come out from the mineral cube.
· Wait until the Vitalizer Plus has completed its cycle.
· Empty the pitcher.
If the Vitalizer Plus had not been used for an extended period of
time, we recommend performing cleaning steps.
· Pour filtered water into the pitcher.
· Place the pitcher on top of the base.
· Turn power on.
· Press the minute button to select cycle time. (9, 18, 27
minutes).
· Press start/stop button to operate. The LED display will
show the remaining minutes during the operation.
When it is finished, zero “0” will appear on the LED
display and the system will automatically stop.
Do not remove the pitcher from the base while the unit is in
operation. If you wish to stop the unit at anytime, press the
start/stop button to cancel operation.
To Next Page
Loading...
Need help?
General
