Vortice CA - User Manual

48 pages

Save Page as PDF

To Next Page

CA - CA Q

Centrifugo assiale - Centrifugal in-line - Centrifuge axial - Axialer

Zentrifugalabluftventilator - Centrífugo axial - Centrífugo axial - Axiale

Centrifuge - Axialcentrifug - Odśrodkowy osiowy - Tengelyes elszívó

centrifuga - Odstředivý ventilátor s axiálním výfukem - Centrifugal axial -

Centrifugalni osovinski - Eksenel santrifüj - º˘ÁﬁÎÂÓÙÚÔ˜ ·ÍÔÓÈÎﬁ˜ -

éÒÂ‚‡ﬂ ˆÂÌÚËÙÛ„‡ - -

Libretto d’istruzioni

Instruction booklet

Notice d’emploi et d’entretien

Betriebsanleitung

Manual de instrucciones

Manual de instruções

Gebruiksaanwijzing

Instruktionshäfte

Instrukcja

Használati utasítás

Uživatelská příručka

Manual de instrucţiuni

Upute za uporabu

Kullanım kılavuzu

∂Á¯ÂÈÚ›‰ÈÔ Ô‰ËÁÈÒÓ

àÌÒÚÛÍˆËË ÔÓ ˝ÍÒÔÎÛ‡Ú‡ˆËË

MADE IN ITALY COD. 5.371.084.180 26/05/2005

VORTICE LIMITED

Beeches House - Eastern Avenue

Burton on Trent

DE13 0BB

Tel. (+44) 1283-492949

Fax (+44) 1283-544121

UNITED KINGDOM

VORTICE ELETTROSOCIALI S.p.A.

Strada Cerca, 2 - frazione di Zoate

20067 TRIBIANO (MI)

Tel. (+39) 02-90.69.91

Fax (+39) 02-90.64.625

ITALIA

VORTICE FRANCE

72 Rue Baratte-Cholet

94106 Saint Maur Cedex

Tel. (+33) 1-55.12.50.00

Fax (+33) 1-55.12.50.01

FRANCE

Main Page

Questions and Answers

H
Hunter HillJul 29, 2025
What to do if my Vortice Fan does not start?
- W
  watsonjamesJul 29, 2025
  If your Vortice Fan doesn't start, there might be several reasons: * The motor could be faulty, in which case you should replace the motor. * The capacitor may be defective; consider replacing it. * The speed controller might be incorrectly connected, so verify the connections. * There could be bad contact on the terminal board. To resolve this, disconnect the appliance, remove the terminal board cover, and inspect the wiring.
A
Angela GonzalezAug 11, 2025
Why does my Vortice CA keep stopping?
- L
  Laura HernandezAug 12, 2025
  If your Vortice Fan stops, it could be due to a few reasons: * A blocked duct. In this case, check the electrical connections. * The duct being too long or having too many bends or filters. To solve this, shorten the duct, install a more suitable Vortice appliance, and check for pressure drops. * A faulty capacitor. If this is the case, replace the capacitor.