VOSS.SONIC 2000 - Assembly and First Time Operation; Location and Charging Guidance; Device Activation and Operation; Frequency and Sensitivity Settings

12 45022| 08 | 2020 | V 1
INSTRUCTION MANUAL VOSS.SONIC 2000
Outdoors the unit should be located approx. 15 cm above the ground. This ensures an ideal detection range and good
ultrasonic dispersion.
When choosing a location make sure the unit does not become a tripping hazard for other people.
Important tip
Insuciently charged batteries cannot trigger the ash.
If the battery voltage is too low, the ultrasonic signal may also be aected.
If the batteries are too weak, they must be charged.
Operation
Important notice
If the batteries are insuciently charged, the LED light starts ashing red. In this case connect the device to a USB port
(computer, laptop, mobile phone charger, etc.) using the provided cable. Once the batteries are fully charged, the red LED
will glow continuously.
To maximise the battery capacity, we recommend for the rst 3 times to wait until the batteries are completely discharged,
before charging them again. This way the memory eect is avoided. The battery memory eect is a reduction in the longevity
of a rechargeable battery‘s charge, due to incomplete discharge in previous uses. Some types of batteries, such as nickel-
cadmium and nickel-metal hydride, can develop a memory eect when only partially discharged before recharging.
Due to the dierent transport, storage and shipping times until the rst use, it may be necessary to charge the batteries. This
is not unusual. When the device is switched on. the red LED light in the upper half of the ash window lights up for approx.
5 seconds.
After a further 25 seconds the unit is ready for operation. Now the motion detector can be triggered. After a short, audible
start click, the device emits ultrasonic sounds for approx. 9 seconds. As a visible function monitoring, the light behind the
motion detector also lights up red. The VOSS.sonic 2000 starts working as soon as the motion detector is triggered. The
device is now ready for operation.
Frequencies
You have the choice of 5 dierent ultrasonic frequencies. Level 5 emits a frequency mix from all levels.
Settings
The „Sens.“ dial (left) controls the setting of sensitivity and distance. By turning the dial clockwise you increase the range and
coverage.
To frighten small animals, turn the „Sens.“ dial all the way to the right.
The „Freq.“ dial (right) controls the frequency. By turning the dial clockwise, you increase/change the emitted frequency.
0 : OFF
1 : Scares animals like dogs, cats, raccoons, ...
2 : Scares animals like foxes, wild boars, deer, ...
3 : Scares little rodents, rats, martens, badgers, otters, rabbits, hares ...
4 : Flash adds to the deterrent eect, especially frightens birds
5 : Functions 1-4 are activated (switching between frequency modes 1, 2 and 3) together with the ash.