normal f or a sma ll amo unt of water to come out of th e sa lt co ntaine r.It is
1. The sa lt co ntainer must only be refilled when the salt warning light in the control panel comes on.
Depending on how fully the salt dissolves, the sa lt warning light may still be on even though the
salt container is filled.
If there is no salt warning light in the control panel (For some Models),yo u can judge when to load
the salt into the softener by the cycles that the dishwasher had run.
2. If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.
Always u se salt int end ed for use with dishwash er.
The salt contai ner is loca ted beneath the ba sket and should be fille d as f ollows:
Attention!
Only u se sa lt specific ally design ed for use in dishwashers ! All o ther t ypes of
salt not sp ecifically desi gne d for us e in a d ishwasher, es pec ially ta ble salt , will
damage the water so ftener. in case of dam ag es ca used by the us e of u nsu itab le
salt the m anu fa cturer does no t give any wa rran ty nor is lia ble for any cause d
damage s.
Only f ill with s alt just befor e start ing o ne of th e comple te washin g programmes.
This will preve nt an y gr ains of salt or salt y wate r, wh ich m ay have been split,
remain ing of th e bottom of the machine f or any period of time, wh ich m ay cause
corrosion.
4
A Remove the baske t an d t hen uns crew and remove t he cap fr om the sa lt co ntainer.
B B efore first wash, add 1lt. of water in the salt container of your mac hine.
C P lace the end of the funnel (su pplied) into the h ole an d intro duce about 1k g of salt.
D A fter fill ing the container , sc re w th e ca p tight ly bac k clockwis e.
E U sual ly, the salt war ning ligh t wil l be cease to b e i lluminat ed wit hin 2-6 d ays afte r t he salt c onta in er h as b een filled with
s alt.
F Immediately after fill in g t he salt i nt o t he s alt c ont ainer, a wash in g progra mme sh ou ld be start ed
Otherwise filter s ys te m, pump o r other impo rtant p ar ts of the machi ne ma y be d amaged by s alty
wat er. I t is out o f warranty.
If your model have water softener, you may ski p this section.no
Step 1: Enter the stat us of salt adjustm ent
Adjusting Salt Consumption
Close the door, within 60 seconds after power on, press Start/Pause button and hold for 5 seconds,
the machine will enter setting mode.
To Next Page
Loading...