There are 6 levels of salt consumption in all.It is recommended to select the level according to below table:
Step 2: select a certain level of salt con sump tion
Contact your local water board for information on the hardness of your water supply.
Press the Start/pause button to select the proper set according to your local environment,
the sets will change in the following sequence: H1->H2->H3->H4->H5->H6;
Step 3: Exit the status of salt adjustmen t
Without any operation in five seconds, the machine will exit from set mode, the machine is into standby status
1) German degree of measurement for the water hardness
2) millimol, internationel unit for water hardness
*) factory settin g
The r inse aid is relea se d dur ing the final rinse to prevent water from forming drople ts on your dish es. T hat can l eave
spots and s treaks. It also impro ves dryi ng by allowing water to sheet of f the dishes. Your dishwasher is desi gned to
use li quid rinse aids . The rinse aid dispenser is located inside the doo r next to the detergent dispenser. To fill the
dispenser, open th e cap and pour the rinse aid into the dispenser until t he level indi cator tur ns com pletely black.
The volume of the ri nse aid cont ainer is about 110ml.
Rinse Aid Dispenser
Function of Rinse Aid
Rins e aid is automaticall y added dur ing the l ast r inse, ens uri ng t horough rinsi ng, and spot and st reak fr ee dryi ng.
5
Setting on the
w ater softener
Digital display stalls
1
Rapid
2
3
5
dH
Water Hardness level
mmol/l
1)
2)
0-5 0-0.9
6- 11 1.0-2.0
12-17
18-22
23-34
35-45
2.1-3.0
3.1-4.0
4.1-6.1
6.2-8.0
Glass & Rapid
ECO
ECO & Rap id
ECO & Glass
Glass
6
4
*
To Next Page
Loading...