5
8 Ohm: Allows for the following configurations:
1) Set it to this if you connect an extension cabinet. You’ll be running the
internal and external speaker in parallel. The impedance of the extension
cabinet must be 16 Ohms.
2) Set it to this if you connect an external 8 ohm cabinet and disconnect
the internal speaker.
Model AC15CC1X
This has an 8ohm loudspeaker internally fitted and the amplifier must be
set at 8ohm output. This speaker must be disconnected if amplifier is used
with an extension cabinet.
3. Footswitch jack: This is where you connect the supplied VF002 VOX footswitch so you can
turn the Reverb and Tremolo on and off.
4. HT Fuse: This fuse protects your amp should a fault occur with the power. The most
common reason for this fuse to blow is when an output tube becomes
faulty. The correct value of the HT fuse is located on the rear panel of the
amplifier and should only be replaced with one of the same value.
5. Mains Input: This is where the supplied, detachable Mains (power) cord is connected.
The specific mains input voltage rating that your amplifier needs to run at
is located on the rear panel of your amplifier. Before making any connec-
tions or powering up the amplifier, make sure the correct voltage is set. If
you have any doubt, refer to your local VOX dealer.
6. Mains Fuse: This fuse provides an overall safety protection in the event your amplifier
develops and electrical fault. The correct value of the fuse is located on the
rear panel of your amplifier and should only be replaced with one of the
same value.
Specifications
Power Output: 15 Watts RMS into an 8 or 16 ohm loudspeaker load.
Internal speaker: 16 ohm, 12", 30 Watt VOX/Wharfedale Custom—model AC15CC1
8 ohm 12", 15 Watt VOX/Celestion AlniCo Blue—model AC15CC1X
Valve/tube complement:
2 x EL84/6BQ5 & 2 x 12AX7/ECC83.
Rectifier: silicon rectifier with passive SAG circuit.
Mains input: preset 100V or 120V or 230V or 240 V ~ 50 or 60 Hz depending on country
of sale. Please see Rating Plate on rear of amplifier for exact specification.
Mains Fuse value: 250V, T1.6AL for 100V / 250V, T1.25AL for 120V
250V, T630mAL for either 230V & 240V.
Warning!—Replace fuse with same type and rating
HT Fuse: 250V, T250mAL.
Dimensions: 605 x 262 x 440 mm / 23.82" x 10.31" x 17.32"
Weight: AC15CC1: 21.6kg / 47.62 lbs. , AC15CC1X: 21.7kg / 47.84 lbs.
Included items: Power cable, VF002 footswitch
Appearance and specifications of this product are subject to change without notice.
URL = http://www.voxamps.co.uk
To Next Page
Loading...
Need help?
General
