18
Using the tuner
The tuner function lets you tune a guitar that’s connected to the INPUT jack.
1. Press the TUNER (BYPASS) switch. All effects will be bypassed
and the tuner function will be turned on.
Bypass indicator (No valid signal is input.)
HINT: If you want to tune your guitar with the amp
output muted, hold down the TUNER (BYPASS) switch
for one second or longer. When the amp is muted, the
TUNER (BYPASS) LEDs will blink.
2. Play any open string.
NOTE: Be careful not to play other strings accidentally.
3. Tune the string casually so that, from among five LEDs (BANK LED and CH 1–
4 LEDs) only the LED that corresponds to the string lights up.
6th (E) 5th (A) 4th (D) 3rd (G) 2nd (B)
1st (E)
4. Tune the guitar precisely while observing the TUNER (BYPASS) LED indica-
tors.
Sharp
Slightly sharp
In tune
Slightly flat
Flat
5. Press the TUNER (BYPASS) switch again to complete tuning.
To Next Page
Loading...
Need help?
General
