Operation
INSTALLATION
To install the VRBT200V attach to the visor of your vehicle using the clip on the rear of
the unit.
CHARGING
Insert the mini USB connector of the charging adaptor into the mini USB charging port
of VRBT200V, then insert the 12 Volt adaptor end into the vehicle’s cigarette lighter
socket or 12 Volt Power Port. If the unit is ON, it will automatically shut OFF when you
start charging, and the Red LED will come on to indicate the unit is charging. When the
VRBT200V is fully charged, the Red LED will go off.
LOW BATTERY WARNING
When the VRBT200V battery is low, the Blue LED will be off, and the Red LED will ash,
and the speaker will make a BEEP sound.
POWER ON AND OFF
Press and hold the Multi-Function Button for 3 seconds to turn the VRBT200V ON.
There will be a short BEEP and the cancel button will ash blue. When the VRBT200V is
in standby mode, press and hold the Multi-Function Button for 3 seconds to turn the unit
off. You will hear a long BEEP, and both LED lights will turn off.
MULTI-FUNCTION BUTTON
POWER - Press and hold for 3 seconds.
PAIRING - Press and hold for 6 seconds
ANSWER A CALL - Press once
RE-DIAL - Press two times or more, depending on your phone’s features.*
VOICE ACTIVATED DIALING - Press Once*
CALL TRANSFER - Press once to transfer to VRBT200V
Press and hold for 3 seconds to transfer to cell phone
MUTE - Press and hold for 3 seconds
THREE WAY BUTTON
VOLUME - Move the 3-Way button to the right to increase, or move the 3-Way button
to the left to decrease.
CALL WAITING* - With a call in progress you will hear 2 short tones, then:
1. Press and hold the 3-Way button to the right for 3 seconds to put the current call on
hold and answer the waiting call.
Note: To cancel the second call and return to the “call on hold”, press the cancel but-
ton once.
2. Press and hold the 3-Way button to the left for 3 seconds to cancel the current call
and answer waiting call.
MUTE - Press and hold for 3 seconds to Mute or Unmute.
ENTER CALL LOG BOOK - Press Once
TO CHOOSE A CALL LOG BOOK - Move to Left or Right
CANCEL BUTTON
END CALL - Press Once
REJECT CALL - Press Once
EXIT CALL LOG BOOK - Press Once
PAIRING WITH A BLUETOOTH
®
ENABLED CELL PHONE
1. The VRBT200V and the Bluetooth
®
enabled cell phone should be within a distance of
3 feet (1 meter).
2. With the VRBT200V OFF, press the Multi-Function button for 6 seconds. The Red &
Blue LEDs will ash alternately and the speaker will make a long BEEP sound.
3. The Bluetooth
®
cell phone will search for nearby Bluetooth
®
devices. The cell phone
will display the “VRBT200V” in the list of Bluetooth
®
devices. If you are using a “dongle”
type Bluetooth
®
adaptor, follow the manufacturers’ instructions for that device.
4. Select “VRBT200V” to add this Bluetooth
®
device into the list of paired devices.
5.
Enter in the PIN Code “0000” and your mobile phone will show that pairing is complete.
6. If pairing is successful, user will hear a long BEEP and the Blue LED will ash about
every 3 seconds.
CALLER ID DISPLAY
The LCD will ash ON & OFF while displaying the phone number of the incoming call. On
the rst screen, the rst ten digits will be displayed, the rest of the digits will be displayed
on the last screen.
To Next Page
Loading...