VR46 Kiddy - Brake Adjustment

09
Checkthebrakestomakesuretheyareefcient.Makesurethatthebrakesdonotdragwhentheleveris
not being pressed. Do not ride the electric scooter if the brakes are not working properly.
Tools required: 10 mm wrench
7. Brake adjustment
Before using this product under any circumstances, check that the
brake is working properly
IMPORTANT
1. To adjust the brake cable, turn the adjuster barrel on
the brake lever clockwise (to loosen) or counterclockwise
(to tighten). Rotate the cylinder only a little at a time,
until the desired adjustment is reached. If the brake still
needs further adjustment, proceed to the next step.
2. If the brake cable is still too tight or too loose, use a 10
mm wrench to loosen the brake cable clamp bolt to carry out
further adjustments on the cable. Ensure that the 10 mm nut
is securely tightened after the adjustment has been made.
Tighten
Loosen