Beverage Cooler | 6
Parts List
PLACEMENT
• Before using the cooler, remove all packaging materials, including bottom
cushions, foam pads, and tape inside the cooler. Tear off the protective film on
the door and the cooler body.
• Make sure the cooler is placed in a well-ventilated, indoor environment on flat,
sturdy ground (turning clockwise to raise the appliance, and counter-clockwise to
lower the appliance).
• Leave a minimum of 1/2” between each side of the appliance and the wall.
The top and back of the appliance should have a minimum 2” clearance. This
allows for proper air circulation.
• Avoid putting the cooler in direct sunlight or too close to a heat source. Keep
a safe distance of at least 12 inches between the cooler and a stove or furnace if it
can’t be avoided. We also advise applying an insulation board in that case.
• Install the appliance in a location where the temperature is between 55°F and
90°F. For best performance, do not install the beverage cooler behind a cabinet
door.
1
4
2
3
1
Glass Door
2
Shelf Racks (3)
3
Electronic Control
4
Leveling Leg
To Next Page
