14
OR
To secure to the side wall use a
Philllps screw driver and a black
wood screw (see step 3). CAUTION:
Do not over tighten the screw.
To secure to the door frame, use
a black wood screw to secure the
sliding arm (pre-drill: see step 3).
Step
9
To completely secure the Vroom there are two options:
OR
Securing the unit....
Connect the Vroom motor compartment
to the hose management case by
connecting them with flex hose and
hose clamps (included).
Step
10
Connect the pre-stripped wires
from the hose management
case to the wires from the
motor compartment using wire
nuts (provided).
Step
11
To secure motor compartment
to the base of the cabinet, peel
the easy release tape. NOTE:
Use the alcohol wipes to clean
base cabinet (included)
Step
12
Plug the motor compartment
into a grounded 120V outlet.
You are ready to clean!
Step
13
VROOM Solo Specifications
Part Number 9170
Model Number Vroom Solo/Model 88500
Replacement Filters and Bag Part Numbers 7767-V Debris Bag (3 Pack)
4929 Filter
4928/4934 Filter Support
Air Watts 450
CFM 120
Sealed Vacuum 105”
Electric Power Cord Length 6’ Plug Type 15 Amp,
(NEMA type 5-15p) 2 pole, 3 wire
Dirt Container Capacity 1 Gallon
Voltage 120 Volts (AC)
Amperes 11.3 Max/8.5 Avg
Electrical Requirements* 120V/15 Amp Circuit. Separate Circuit
Recommended. For 15A Circuit use NEMA 5-15R
* It is recommended that this unit is plugged into a dedicated circuit or a circuit that is
unlikely to be used simultaneously with the Vroom. (i.e. garbage disposal)
To Next Page
Loading...
