STEAM STRAIGHT BRILLIANCE
11
To use the straightener with steam, without the base station:
1. Remove the water reservoir located at
the bottom of the straightener by pulling
the release switch down with one hand
& removing the water reservoir with the
other hand.
2. Lift the black rubber plug & using the pipette, fill with distilled
water (We recommend using distilled water as this will help
protect the appliance best & lessen the chance of clogging
the inside mechanism that allows the steam to flow through).
The straightener water reservoir holds 10ml of water & will
provide around 6 minutes of steam usage time from a full tank.
Replace the black rubber plug & put the reservoir back on the
straightener until it clicks into place. Check that the reservoir
is properly positioned & secured in place.
3. Press the On/Off
( )
button to turn your straightener on. The
default 140°C LED indicator will illuminate & start to flash. At
this point the straightener will start heating up.
4. Press the steam
( )
button once to switch on the steam
function. The steam LED indicator will illuminate.
5.
When using the steam function & the plates are closed, the
straightener will make a clicking sound. This is completely
normal & part of standard operation as the pump is pushing
the water through the inside mechanism.
ALWAYS remove excess water from the base station water
reservoir + the base station bottom tank + the straightener
water reservoir after use, since leaving unused water in the
reservoirs can cause clogging over time.
NB - NEVER add any other liquid aside from distilled water to
the water reservoirs.
To Next Page
Loading...
