VTech Baby Learning Lights Sudsy Soap User Manual

4
4
4
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF
2. Locate the battery cover on the back
of the unit. Use a screwdriver to
loosen the screw and then open the
battery cover.
3. If used batteries are present,
remove these batteries from the unit
by pulling up on one end of each
battery.
4. Install 2 new AAA batteries following the diagram inside the
battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
of children.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommended
are to be used.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use.
• Removeexhaustedbatteriesfromthetoy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinfire.

VTech Baby Learning Lights Sudsy Soap Specifications

General

Brand	VTech Baby
Model	Learning Lights Sudsy Soap
Category	Toy
Language	English