42
The feature is preset to AUTO. You may also manually
change the power fail back-up setting.
To change the power fail back-up setting
Press MENU when the handset is not in use.
Press
or to scroll to HS SETTINGS.
Press OK and
or to scroll to POWER OUTAGE.
Press OK and
or to select MANUAL, AUTO or
OFF.
Press OK to save your selection. You hear a
Notes:
If OFF is selected, Power Fail Back-Up mode will
not be enabled.
If AUTO is selected, the registered handset(s)
will display TO PWR UP BS PUT IN CRADLE when
mains power interruption occurs. Place the
not lower than level 2) onto the main base unit
to activate Power Fail Back-Up and start up the
base. If handset is already on the main base unit it
will automatically activate the Power Fail Back-Up
up the base. If AUTO is selected and handset is
not returned to base unit within approximately
2 minutes the handset will temporarily revert to
Manual mode to converse battery power.
If MANUAL is selected, the registered handset(s) will
display TO PWR UP BS PRESS TALK OFF when mains
power interruption occurs. Press and then place
the handset onto the main base unit to activate the
Power Fail Back-Up mode and start up the base.
•
•
•
1.
2.
3.
4.
5.
To Next Page
Loading...
Need help?
General
