VTech 3-in-1 Ride with Me Motorbike - Getting Started; Battery Removal and Installation; Battery Notice

To Next Page

To Previous Page

WARNING! Protective equipment should be worn. Not to

be used in traffic. 20kg Max. Please wear helmet, gloves,

knee pads and elbow pads.

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned Off.

2. Find the battery cover located on the

bottom of the interactive dashboard and

use a screwdriver to loosen the screw

and open the battery cover.

3. Remove old batteries by pulling up on

one end of each battery.

4. Install 2 new AA (LR6/AM-3) batteries

following the diagram inside the battery

box.

5. Replace the battery cover and tighten the screw to secure.

BATTERY NOTICE

• Use only batteries of the same or equivalent type as recommended.

• Do not mix different types of batteries: alkaline, standard (carbon-

zinc) or rechargeable, or new and used batteries.

• Do not use damaged batteries.

• Insert batteries with the correct polarity.

• Do not short-circuit the battery terminals.

• Remove exhausted batteries from the toy.

• Remove batteries during long periods of non-use.

• Do not dispose of batteries in fire.

• Do not charge non-rechargeable batteries.

• Remove rechargeable batteries from the toy before charging (if

removable).