VTech 3-in-1 Step & Roll Motorbike User Manual

5
5
5
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the interactive dashboard and
use a screwdriver to loosen the screw and
open the battery cover.
3. Remove old batteries by pulling up on one
end of each battery.
4. Install 2 new AA (LR6/AM-3) batteries
following the diagram inside the battery
box.
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity (+ and - ).
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.

VTech 3-in-1 Step & Roll Motorbike Specifications

General

Recommended Age	1-3 years
Material	Plastic
Manufacturer	VTech
Features	music and sounds
Color	Multi-color
Style	Motorbike