6
GETTING STARTED
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit. Use a screwdriver to
loosen the screw and then open the battery cover.
3. If used batteries are present,
remove these batteries from the unit
by pulling up on one end of each
battery.
4. Install 2 new AA (AM-3/LR6)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and
tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
To Next Page
Loading...
