VTech Blast-Off Space Station - GETTING STARTED; BATTERY INSTALLATION - ROCKET

6
GETTING STARTED
BATTERY INSTALLATION – ROCKET
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the rocket. Use a coin or
a screwdriver to loosen the screw.
3. Install two new “AAA” (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance.)
4. Replace the battery cover and tighten
the screw to secure the battery cover.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteriesfrom the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
GETTING STARTED