VTech Bounce & Discover Llama - Getting Started; Battery Removal and Installation

4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the back
of the handle. Use a screwdriver to loosen
the screw and then open the battery cover.
3. Remove old batteries by pulling up on the
side of each battery.
4. Install 2 new AAA batteries following the
diagram inside the battery box. (The use
of new alkaline batteries is recommended
for maximum performance.)
5. Replace the battery cover and tighten the
screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommended
are to be used.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.