Getting started
4
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the installation
is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to
digital service from a cable company or a VoIP service provider, the telephone
line may need to be rewired to allow all existing telephone jacks to work.
Refer to Rewiring of telephone line for cable/VoIP service users on page 8
for more information.
•
•
If the handset will not be used for a long time, disconnect and remove the
battery to prevent possible leakage.
To purchase replacement batteries, visit our website at
www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to
www.vtechcanada.com or dial 1 (800) 267-7377.
•
•
Charge the handset by placing it in the telephone base or charger. The
CHARGE light is on when the handset is charging.
4.
Battery installation (continued)
CHARGE light
remains on when
charging.
To Next Page
Loading...
Need help?
General
