6
Getting started
Installation options
Your telephone base is ready for tabletop use. If you want to mount yourIf you want to mount your
telephone on a wall, use the provided wall bracket to connect with a standard
dual-stud telephone wall mounting plate. If you do not have this mounting
plate, you can purchase one from many hardware or consumer electronics
retailers. You may need a professional to install the mounting plate.
Tabletop to wall mount installation
Plug the power cord and
telephone line into the telephone
base. If you are using DSL
lter, plug the other end of the
telephone line into the lter.
Route the telephone line cord (or
DSL lter) through the wall mount
bracket hole.
Position the telephone base as
shown below. Insert the extended
tabs (marked B) of the wall
bracket into the slots on the back
of the telephone base (marked
B). Push the telephone base
down until it clicks securely
in place.
1.
2.
Plug the telephone line cord (or
DSL lter) into the wall jack. Plug
the power adapter into a power
outlet not controlled by a
wall switch.
Align the holes on the bracket
with the standard wall plate
and slide the bracket down until
it locks securely. Bundle the
telephone line cord and power
adapter cord neatly with
twist ties.
3.
4.
To Next Page
Loading...
