Appendix
100
California Energy Commission battery charging testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These instructions are
intended for California Energy Commission (CEC) compliance testing only.
When the CEC battery charging testing mode is activated, all headset functions, except battery charging, will be disabled.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all handsets are plugged with charged
batteries before proceeding.
2. While you
press and hold FIND HANDSET, plug the telephone base power adapter back to the power outlet.
3. After about 20 seconds, when the
IN USE light starts flashing, release FIND HANDSET and then press it again
within 2 seconds.
When the phone successfully enters the CEC battery charging testing mode, the IN USE light turns off and all
handsets display To register HS, see manual.
When the phone fails to enter this mode, repeat Step 1 through Step 3 above.
Note: The telephone base will be powered up as normal if you fail to press FIND HANDSET within 2 seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in. Then the telephone base is
powered up as normal.
2. Register your handsets back to the telephone base. See
page 75 for handset registration instructions.
To Next Page
Loading...
Need help?
General
