VTech Go! Go! Smart Wheels Ramp It Up Dump Truck - Getting Started; Battery Installation and Notice

4
4
4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover on the
bottom of the truck. Use a coin or a
screwdriver to loosen the screw and
open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AAA(AM-4/LR03)
batteries following the diagram inside
the battery box.
5. Replace the battery cover and
tighten the screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeas
recommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard
(carbon-zinc)orrechargeable,ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging
(ifremovable).
• Rechargeablebatteriesareonlytobechargedunder
adult supervision.
DO NOT USE RECHARGEABLE BATTERIES.