VTech Go! Go! Smart Wheels Revved Up Raceway - GETTING STARTED; BATTERY INSTALLATION; BATTERY NOTICE

6
6
6
GETTING STARTED
BATTERY INSTALLATION
Race Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the Race Car. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance.)
4. Replace the battery cover and tighten
the screw to secure the battery cover.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable, or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteriesfrom the toybefore charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.